S600 User Manual 1
FCC Regulations: zThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. zThis device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
The S600 development Kit is used to debug the Franklin Wireless M600 series module. It is designed by an auxiliary board with Franklin Wireless M600 series module embedded. When the S600 is used, you can connect the module to a PC through a USB cable. When the module works normally, the debugging functions can be implemented. The S600 provides multiple interfaces, such as the Mini-USB port, DC power jack, RF connectors. The S600 can be used to test the performance of the module.
Figure-3. Configuration for Adjustment and Test of WIMAX mode 2. Diagram of connecting the S600 and the antenna Figure-4. Diagram of connecting the module and the antenna Table-1.
IV. Installation of the S600 z z z Connect the devices and set up the test environment according to Figure-2 or Figure-3. Then connect the S600 to the PC through a Micro-USB to Type A USB cable.. When performing the wired connection test, connect the E5515C to the RF interface of the S600.. (For the connection method, see Figure-2 and Figure-3) When performing the wireless connection test, connect the antennas to the RF interface of the S600 directly. (For the connection method, see Figure-4.) V.