Owner's Manual

Page 7For technical questions, please call 1-888-866-5797.Item 58307
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Attach Crossarms to Cradle
The Crossarms are interchangeable.
Slide the tapered plate on each Crossarm
into a receiving socket on the Cradle Beam
until the Spring Tab locks into place.
Cradle
Beam
Crossarm
Tapered
Plate
Crossarm
Properly
Installed
Spring Tab
Figure I:
Testing the Assembly
1. With assembly completed, check the
Panel Hoist tool to be sure all fasteners
are tight, the Wire Rope is in place and is
undamaged, and the tool is safe to use.
2. Check the Tripod Base to be sure it is firmly
attached to the Telescoping Asm. Be sure the
legs are firmly extended and locked in place.
3. Check the Telescoping Asm. and Winch to be sure
they are properly installed and functioning properly.
4. Check that the Cradle is properly
attached to the Telescoping Asm.
5. Check that the Crossarms are firmly
attached to the Cradle.
6. Raise and lower the Cradle while empty,
checking for proper function, before
operating the hoist with a load.
CAUTION! Check the assembly for proper
function before using this tool.