Operation Manual
56
contact Franklin or its distributors to get info for battery disposal
and/or replacement. However, shipping and handling expenses
might apply.
This unit may change operating modes, lose information
stored in memory, or fail to respond due to electrostatic
discharge or electrical fast transients. Normal operation of
this unit may be re-established by pressing the reset key, by
pressing
, or by removing and replacing the battery.
9.5 FCC Notice (U.S. only)
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause
undesired operation.
Warning: Changes or modications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
1) Reorient or relocate the receiving antenna. 2) Increase the
separation between the equipment and receiver. 3) Connect
the equipment into an outlet on a circuit dierent from that
to which the receiver is connected. 4) Consult the dealer or an