User Guide

FCC Notice

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) This device must accept

any interference received, including interference that may

cause undesired operation.

Warning: Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reason-

able protection against harmful interference in a residential in-

stallation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accor-

dance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that in-

terference will not occur in a particular installation. If this equip-

ment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interfer-

ence by one or more of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment and receiver.

–Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

–Consult the dealer or an experienced radio/TV technician for

help.

NOTE: This unit was tested with shielded cables on the periph-

eral devices. Shielded cables must be used with the unit to in-

sure compliance.

NOTE: The manufacturer is not responsible for any radio or TV

interference caused by unauthorized modifications to this equip-

ment. Such modifications could void the user’s authority to op-

erate the equipment.

ncs-101Plus-02eng_A.pm65 6/25/03, 10:47 AM20