Instructions / Assembly

ManualsBrandsFraser Hill Farm ManualsChristmas Decorations69 in. Musical Globe Lamp Post in Red Featuring Santa Scene and Snow Function

1) Schematic diagram

2) Component list

No.

Name

Number

Lamp top

Lamp holder

Lamp post (17in）

Adapter (12V AC 500mA)

Extended wire (137in)

Power wire (137in)

(inside lamp post: 59in, outside: 78in)

Additional base

1 set（4）

Ground nail

Lamp base

Square base

Brand

Lamp post joint

Wreath+ bowknot

1 set

Power wire of lamp holder

Screw

4+1

Note: 1,2,3,4,5,6 are all wire joints.

3) Assembling steps

Please assemble the product from the bottom to the up,

following the main steps below:

1. Install lamp base

A. Assemble lamp base (9) and square base (10) with 4

screws:

B. Assemble 4 pieces of additional base (7) into a whole,

and then assemble the whole additional base (7) with the

lamp base (9).

Note: The additional base (7) is designed to fasten the

street lamp more securely. If the street lamp is installed on

a flat ground and there is no external force (such as high

wind or man-made interference), or if the street lamp is

used outdoors and it can be fixed on the ground by

fastening ground nails; there is no need to install additional

base (7). In other words, users can decide whether to

install the additional base (7) according to the actual

condition.

2. Install lamp post

Screw the two lamp posts (3), lamp post joints (12) and

square lamp base (10) together according to the sequence

shown in the figure below. Note: Every screw thread must

be tightened; otherwise, the lamp posts may lean or get loose.

Caution

 This product (especially the lamp holder) is

fragile, do not exert too much strength or drop it

during the assembly and use. Be sure to fix it on

the wall securely.

 Please assemble it in strict accordance with

the steps and requirements specified in the

instruction to ensure safety and reliability

during the installation.

Summary of content (2 pages)

PAGE 1
5 Caution   This product (especially the lamp holder) is fragile, do not exert too much strength or drop it during the assembly and use. Be sure to fix it on the wall securely. Please assemble it in strict accordance with the steps and requirements specified in the instruction to ensure safety and reliability during the installation.
PAGE 2
√ 3. Install lamp holder A. Thread the power wire (6) and its joint (5) through the lamp base and lamp post (the lamp base and lamp post can be laid down or put upside down for convenience. After drawing out the joint (5), place it correctly for later use; B. Power on: Tightly connect the two joints 1 and 4 of the adaptor (4) and power wire (6). If the power wire isn’t long enough, it is able to add the extended wire (5) between them, and then connect the adapter (4) with the main power source. C.