Use and Care Manual

Schematic diagram

Component list

No. Name Number

1 Lamp top 1

2 Lamp holder 1

3 Lamp post (17in） 2

4 Adapter (12V AC 500mA) 1

Extended wire (137in) 1

Power wire (137in)

(inside lamp post: 59, outside: 78in)

Base trim

1 set

（

4）

Ground nail

Lamp base

Square base

Plaque

Lamp post joint

Wreath+ bowknot

1 set

Power wire of lamp holder

Screw

4+1

Note: 1,2,3,4,5,6 are all wire joints.

Caution

 This product (especially the lamp holder) is fragile and should be assembled with care.

 This product is waterproof; but it is necessary to keep the lamp in the vertical direction to ensure water

drains correctly.

 Please follow the below steps and requirements specified in the instruction to ensure safety and

reliability during the installation.

PAGE 1
   Caution This product (especially the lamp holder) is fragile and should be assembled with care. This product is waterproof; but it is necessary to keep the lamp in the vertical direction to ensure water drains correctly. Please follow the below steps and requirements specified in the instruction to ensure safety and reliability during the installation. Schematic diagram Component list No.
PAGE 2
Assembly Instructions 1) Install lamp base Please assemble the product from the bottom to the up, following the main steps below: A. Assemble lamp base (9) and square base (10) with 4 screws: B. Assemble 4 pieces of additional base (7) into a whole, and then assemble the whole additional base (7) with the lamp base (9). 2) Install lamp post Screw the 2 upper and lower posts (3), lamp post joints (12) and square lamp base (10) together according to the sequence shown in the figure below.
PAGE 3
4) Positioning, power-on, Rainproof and examination A. Positioning: Carefully place the assembled street lamp in an upright position. Note: (1) If the street lamp is to be installed outdoor, please fix the lamp base with ground nails in case high wind blows it down; (2) The street lamp should be placed at a location without man-made interference to avoid damages. (3) If the street lamp is being installed indoor and near a man-made interference, please be sure to use additional base (7) to keep it secure.