Use and Care Guide

1) List of parts
No. Description Quantity
1 Transformer 1 unit
2 Base support 1 set (4 pcs)
3
Umbrella-shaped
base
1 set
4 Ring support 1 set (2 pcs)
5 Figures 1 set (3 pcs)
6 Christmas tree 2 trees
7 String 1 string(2 tips)
8
Street lamp
(Combined type)
1 set
9 Brand 1 piece
10 Wreath 1 piece
11 Snow flakes 1 bag
12 Top 1 piece
2) Schematic
3) Installation
Install the base
 Take out the umbrella-shaped base, base
support, fixing screws and transformer.
 Fix the 4 base supports onto the base;

Connect the transformer plug with the base
socket;
 Unfold the umbrella-shaped base.
Install Street Lamp

Assemble the street lamp components as
shown on schematic and insert the plug at
bottom into No. 1 jack in its base. Note: (a ) To
ensure normal functioning of the street lamp
after power on, good contact of connection
wires between each street lamp tube section
shall be ensured. (b) Tighten
each screw so
that each lamp tube forms a strong base of the
product.
Fit ring support and its fittings

Assemble the ring support with its fittings as
illustrated. Note: Fit each item one by one to
their serial No.

Put ring support on umbrella support in the
direction as indicated by
 Mount the figures and Christmas trees one by
one onto the ring support as illustrated.
Arrange the Christmas tree and fit the lamp.
 Straighten up branches of the 2 Christmas
trees as illustrated.
 Insert the plug of Christmas tree into No. 2 jack
in the base and decorate both light strings on
Christmas trees respectively.
4) Check

Confirm again all the above have been
completed;

Clean off all foreign matter in the snow
container, to avoid them blocking the flow of
snow flakes;
 Set the
switch at OFF and connect the
transformer with power source;
 Functional test: P
ut a small amount of snow
flakes at the bottom of the snow container, and
turn on the switch to observe if flakes spout out
from the top of the tree.
Music and lamps
should be properly functioning. If there are any
issues, check the contact of wiring and try it
again until all functions are resolved.
5) Pour in the flakes
 Turn off the switch.
Evenly distribute the
snowflakes into the umbrella shaped base. It is
suggested to keep an appropriate amount of
snowflakes aside, for when some fall out.
6) Completion of assembling
 Fit wreath and brand.
 Turn on the switch, you will see snow flakes
spouting from the top of the tree, the lamps
flashing and music starting. Now all assembling
has been completed.
7) Adjust and enjoy
 Adjust the wind switch to get appropriate wind
for best snow flying effect, and also avoid
flakes flying out of the container.
 Music can be controlled by the switch and can
be turned off when not needed:
I –
Music turned off and other functions are
normal；
II—
Music turned on and all functions are
normal.
Special Caution
● The product is for indoor use only and is not
suitable for outdoor or any location with
drafts.
● Use caution with children under the age of 8.
Children should keep a safe distance to avoid
inhaling snow particles and possible
suffocation.