User's Manual

P a g e | 11
Exhibit 9
US7,420,471; US8,169,335; US8,232,888; US5,939,986; US6,810,353; US8,446,277; US8,552,882;
US8,710,979; US8,810,390; US8,847,780; US9,081,046; US9,153,118; AU2005289704; AU2008316786;
AU2009228472; AU2010241545; AU2013315672; ZA2007/02919; ZA2008/02673; ZA2010/06816,
ZA2010/09068; ZA2011/07178 Patent Pending
2.9 Safety Consideration
The driver and pedestrian should not be in close proximity while the truck is in gear. The driver must
turn off the truck while a pedestrian is standing next to the truck. An alternate solution is a switch
applied to the emergency brake to cut the circuit to the generator while the brake is activated.
3 Warranty
HIT-NOT® WARRANTY TERMS AND CONDITIONS
IMPORTANT-READ CAREFULLY: BY AND INSTALLING AND USING THE HIT-NOT
®
SYSTEM, YOU
ACKNOWLEDGE AND AGREE TO BE CONTRACTUALLY BOUND BY THESE WARRANTY TERMS AND
CONDITIONS. IF ANY OF THE TERMS OF USE ARE NOT ACCEPTABLE TO YOU, DO NOT INSTALL OR USE
THE HIT-NOT
®
SYSTEM.
THE HIT-NOT
®
SYSTEM IS SIMPLY A TOOL TO BE USED TO ASSIST YOU IN SAFELY OPERATING HEAVY
EQUIPMENT. THE HIT-NOT
®
SYSTEM IS NOT INTENDED AS A SUBSTITUTE FOR, NOR DOES IT REPLACE,
SAFE PRACTICES IN OPERATING HEAVY EQUIPMENT. YOUR USE OF THE HIT-NOT
®
SYSTEM IS SOLELY
AT YOUR OWN INDEPENDENT DISCRETION AND RISK.
ACCEPTANCE AND DEFINITIONS.
(A) Acceptance of Terms. These Warranty Terms and Conditions (these “Terms”) are a
legal agreement between You, as a purchaser and end user of the System and Frederick Energy
Products, LLC. RETURN THE SYSTEM TO THE DEALER FROM WHICH YOU
PURCHASED THE SYSTEM, IN ACCORDANCE WITH THE DEALER’S POLICIES. This
Agreement constitutes the entire and only agreement between FEP and You and supersedes all
Alerting Signals
• PAD (Pedestrian Alert)
• Warning Zone- Series of 3 beeps
• Danger Zone- Continuous signal
Talking
PAD
Generator
Factory Field Size @ 12-15V:
Warning: 43ft
Danger: 30ft
LOW BATTERY ON
PAD: Series of 2
beeps. PAD will not
indicate Alert Signals!
* To ensure proper functionality under all
conditions the Danger Zone limit should not
exceed 30’. If a larger field is required,
contact Frederick Energy Products for options.
Field Adjust
To check the field,
hold a PAD at the
edge of the Danger
zone on the long axis
of the Generator.
Slowly move the PAD
from Danger to
Warning.
Step 10
Step 9
• Remove bottom cover-see step 8
• Have a Pedestrian with a PAD at the
desired Danger Zone limit * slowly
adjust the “PWM” pot with a 3/32”
slotted screwdriver until the danger
zone alerts at the desired distance.
• Return bottom cover.