User's Manual

Exhibit 9
US7,420,471; US8,169,335; US8,232,888; US5,939,986;
US6,810,353; AU2005289704; ZA2007/02919; ZA2008/02673;
ZA2010/06816, ZA2010/09068 Patent Pending
AU2008316786; AU2009228472; AU2010241545; AU2013315672; ZA2007/02919; ZA2008/02673;
ZA2010/06816, ZA2010/09068; ZA2011/07178 Patent Pending --Réorienter ou déplacer l'antenne de
réception. --Augmenter la distance entre l'équipement et le récepteur. --Branchez l'appareil dans une
prise sur un circuit différent de celui auquel le récepteur est connecté. --Consulter le vendeur ou un
technicien radio / expérimenté. Les changements ou modififications à cet appareil sans expressément
approuvée par la partie responsable de conformité pourraient annuler l’autorité de l’utilisateur de faire
fonctionner cet équipement.
The required notices are specified in the RSS documents (including RSS-Gen) applicable to the
equipment model. These notices are required to be shown in a conspicuous location in the user manual
for the equipment, or to be displayed on the equipment model. If more than one notice is required, the
equipment model(s) to which each notice pertains should be identified. Suppliers of radio apparatus
shall provide notices and user information in both English and French. This device complies with Industry
Canada license-exempt RSS-standards(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. Cet appareil est conforme avecx
Industrie Canada exempt de licence Rss standard(s). Son fonctionnement est soumis aux deux conditions
suivantes: (1) cet appareil ne peut causer d’interférence, et (2) cet appareil doit accepter toute
interférence, y compris des interférences qui peuvent provoquer un fonctionnement indésirable du
périphérique.
The Cab Silencer also complies with Industry Canada (IC) under Category II radio apparatus with
RSS-310:
iWAREHOUSE Field Sense Cab Silencer
Model: # 1309890
IC ID: 11625A-FSSILENCER
Canada 310
2 Operation
2.1 Installation Information
When used to produce a PAD silencing field inside the cab of a lift truck, the Cab Silencer is
mounted inside the cab. The exact location varies depending on lift truck model. The Cab
Silencer must be at least 5 feet away from the MFG. Performance of the Collision Avoidance
Module function of the MFG may be degraded (or silenced) by the Cab Silencer if they are less
than 5 feet apart. Installation on the machine needs to be on a 12VDC source, downstream
from the ignition. After installation on a lift truck, the magnetic field size of the Cab Silencer
should be adjusted using a potentiometer on the printed circuit board such that the silencing
field does not extend outside the operator’s cab. (See Section 2.5 below)
4