User's Manual

Exhibit 9
US7,420,471; US8,169,335; US8,232,888; US5,939,986;
US6,810,353; AU2005289704; ZA2007/02919; ZA2008/02673;
ZA2010/06816, ZA2010/09068 Patent Pending
2.9 Safety Consideration
The driver and pedestrian should not be in close proximity while the truck is in gear. The driver
must turn off the truck while a pedestrian is standing next to the truck. An alternate solution is
a switch applied to the emergency brake to cut the circuit to the generator while the brake is
activated.
3 Warranty
HIT-NOT® WARRANTY TERMS AND CONDITIONS
IMPORTANT-READ CAREFULLY: BY AND INSTALLING AND USING THE HIT-NOT
®
SYSTEM, YOU
ACKNOWLEDGE AND AGREE TO BE CONTRACTUALLY BOUND BY THESE WARRANTY TERMS AND
CONDITIONS. IF ANY OF THE TERMS OF USE ARE NOT ACCEPTABLE TO YOU, DO NOT INSTALL OR USE
THE HIT-NOT
®
SYSTEM.
THE HIT-NOT
®
SYSTEM IS SIMPLY A TOOL TO BE USED TO ASSIST YOU IN SAFELY OPERATING HEAVY
EQUIPMENT. THE HIT-NOT
®
SYSTEM IS NOT INTENDED AS A SUBSTITUTE FOR, NOR DOES IT REPLACE,
SAFE PRACTICES IN OPERATING HEAVY EQUIPMENT. YOUR USE OF THE HIT-NOT
®
SYSTEM IS SOLELY
Step 8
Field Adjust
• Remove the screw under the
PWM arrow.
• Have a Pedestrian with a PAD
at the desired Danger Zone
limit (~34’ max.), slowly adjust
the “PWM” pot with a 3/32”
slotted screwdriver until the
danger zone alerts at the
desired distance.
• Return the screw
Step
9
Silent Zone Adjust
• Factory set to max. of ~22 in. or
56cm.
• To decrease the size, unscrew the
cap from the Cab Silencer.
• Activate a PAD and turn on truck.
• Using a 3/32” slotted screwdriver,
turn the Pot counterclockwise
until the PAD silences at the
desired location.
• Replace cap.
8
Step 7
Cab Silencer
Step
10
Alerting Signals
In order to avoid battery drain while
the vehicle is off, the Cab Silencer
can be connected to a switched and
fused (5A) circuit. Place the Cab
Silencer within 21” (53cm) of the
Operator’s PAD AND 4 ft (1.2m)
away from the generator,
PAD
Forklift
Field Size:
Warning: 43ft
Danger: 30ft
• PAD (Pedestrian Alert)
• Warning Zone- Series of 3 beeps
• Danger Zone- Continuous signal