User's Manual

US7,420,471; US8,169,335; US8,232,888; US5,939,986;

US6,810,353; AU2005289704; ZA2007/02919; ZA2008/02673;

ZA2010/06816, ZA2010/09068 Patent Pending

--Branchez l'appareil dans une prise sur un circuit différent de celui auquel le récepteur est

connecté.

--Consulter le vendeur ou un technicien radio / expérimenté.

Les changements ou modififications à cet appareil sans expressément approuvée par la partie

responsable de conformité pourraient annuler l’autorité de l’utilisateur de faire fonctionner cet

équipement.

The required notices are specified in the RSS documents (including RSS-Gen) applicable to the

equipment model. These notices are required to be shown in a conspicuous location in the

user manual for the equipment, or to be displayed on the equipment model. If more than

one notice is required, the equipment model(s) to which each notice pertains should be

identified. Suppliers of radio apparatus shall provide notices and user information in both

English and French.

This device complies with Industry Canada license-exempt RSS-standards(s). Operation is

subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired

operation of the device.

Cet appareil est conforme avecx Industrie Canada exempt de licence Rss standard(s). Son

fonctionnement est soumis aux deux conditions suivantes:

(1) cet appareil ne peut causer d’interférence, et

(2) cet appareil doit accepter toute interférence, y compris des interférences qui peuvent

provoquer un fonctionnement indésirable du périphérique.

2 Operation

2.1 Installation Information

The Range Adjust Tool is typically a hand-held device is has no specific installation requirements

NOTE: THE RANGE ADJUST TOOL IS POWERED AT ALL TIMES EXCEPT WHEN ITS BATTERY IS

BEING CHARGED OR WHEN THE SPECIAL PLASTIC PLUG IS INSTALLED IN THE BATTERY

CHARGER RECEPTACLE.

2.1.1 Inoperability Warning

When a Range Adjust Tool battery voltage drops to approximately 3.5 Vdc or below while

connected to a Range Adjust Tool, the Range Adjust Tool will signal a low battery condition. This

alert is two rapid beeps of the sounder every 1.6 seconds.