User Manual

Rev: 29 April 2005
The pair device wizard continues with the last
step, which shows the device status and
prompts you to configure the remote device
i.e., so that the pairing can continue.
When you have configured the other end,
enter the Passkey and click on the “Pair”
button and the serial port plug will initiate the
pairing process. When pairing is completed the
status of your device will automatically change
to being paired. Click on the “Finish” button to
complete the pairing process.
“Remote device initiates pairing”
Selecting “Remote device initiates pairing” is the first step to initiate the procedure where the remote
device is responsible for initiating the pair process. Since the plug only accepts a pair request the only
parameter needed is the Passkey that is shared between the two devices.
Enter a passkey, and press the “Pair” button
to configure the local device in the mode
where it waits to be paired from another
device.
A status window informs you that the plug will
wait for the remote device to initiate pairing.
(Please consult the user manual of the remote
device)
When the pairing has been completed, the
Bluetooth address (unique hexadecimal
number) of the paired partner will be shown.
Click “Finish” to exit the device wizard after a
successful pairing procedure or quit by pressing the “Cancel” button.
Page 11(28)