User Manual

Rev: 29 April 2005
2 Configuring your F2M01 serial port plug
Before configuring your F2M01, you must make sure that there is no Bluetooth connection present,
otherwise the plug cannot enter configuration mode, i.e. make sure that no other unit is connected to your
endpoint or that a running corresponding slave unit is not within range of your connecting Serial Port Plug.
To configure your Serial Port Plug, attach the plug to a serial port on your windows based computer. Open
the Free2move configuration program and when prompted, chose the serial port that the plug is connected
to the drop down list as shown below. If the windows configuration is used to configure a Bluetooth module,
enable the ”Use hardware flow control” feature.
If the communication with the plug fails, check your power supply and make sure that the device has no
active Bluetooth connection.
When the Serial Port Plug is detected the configuration software initializes, and the following screen
becomes visible:
Page 5(28)