User's Manual

Connect cable A (from the handlebars) and B (from the
main frame). Make sure the clip on cable A is properly
aligned with cable B. Connecting A and B incorrectly
can lead to power problems in the monitor. Carefully
position the connected wires into the main frame tube.
Fit the handlebars (part D) on the frame and screw in
the screws (part J3), make sure the holes and screws
are aligned.
Put the screw cover (part H) on the handle platform to
cover the screws. Push it down when you match the
position and holes.
* To remove the screw cover, first remove the screw on
the cover to release the bolt.
STEP 2
3. Find the left and right pedals (part F). Look for
either an L or R symbol on the crank and axle to
distinguish between left and right respectively.
Twist the pedals into their respective sides of the
bike. The left pedal turns counterclockwise, and
the right clockwise. Tighten with a 15mm wrench.
* Please test ride the bike slowly after assembly and
tighten the pedals accordingly to ensure safety.
STEP 3
6mm
J3
H
D
15mm
F-R
F-L
α
β
13mm
J4
G
A
STEP 4
Remove the saddle (part G) and install it
onto the bike. Ensure the saddle is
pushed all the way to the bottom of the
frame and use 13mm wrench to tighten
the seat-fixing nuts firmly on both sides
of the saddle. Screw and secure screws
J4 through the middle of the saddle.
Connect the beta cable (on part A) and
alpha cable (on part G). Carefully
position the metal pins inside. Once
connected, spin the silver metal cover
to lock the cables in place.
A
B