Installation Guide

Owner's Manual
Version
1.0
Chatham Aluminum
Rail & Stair Kit*
PLEASE READ OWNER'S MANUAL COMPLETELY
BEFORE INSTALLING
INSTALLATION INSTRUCTIONS
34109825BOM V1 2/13
Tools Needed:
• Level
• Drill & bits
• Hacksaw or Chopsaw
• Tape Measure
• Pencil
• Clamps
To register your product, please visit: www.barretteoutdoorliving.com/product-registration
3" Temporary
Spacer Blocks
Figure 4
Figure 5
Figure 6
Figure 3
Figure 2
Figure 1
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
Closely follow post installation instructions.
Open up (“unrack”) rail section.
Cut two 3" tall temporary wood spacer blocks (not included) to insert under
ends of railing sections to temporarily assist in aligning section
(Figure 1)
.
Slide top and bottom rail brackets on ends of pre-built rail sections
(Figure 2)
.
Slide rail section and brackets between posts and on top of temporary wood
spacer blocks. (Position wood spacer blocks next to installed aluminum posts)
(Figure 1)
.
Using a
1
⁄
1
⁄
1
8
⁄8⁄
" drill bit, carefully pre-drill all four bottom bracket screw holes on one
post
(Figure 3)
.
Install
3
⁄
3
⁄
3
4
⁄4⁄
" screws (included) to attach bracket to post
(Figure 4)
.
Repeat steps 6 & 7 for remaining bottom bracket and both top brackets.
Using a
1
⁄
1
⁄
1
8
⁄8⁄
" drill bit, pre-drill all brackets (top and bottom) through side hole
(Figure 5
).
(Figure 5).(Figure 5
Install
3
⁄
3
⁄
3
4
⁄4⁄
" screws (included) into side bracket holes to attach brackets to
rails
(Figure 6)
.
Make sure your project meets local building codes before beginning installation
*2 Person Installation Recommended
Refer to www.BarretteOutdoorLiving.com for specifi c details about warranty limitations. 1-800-336-2383
*Chatham railing and posts are for decorative use only. DO NOT install on decks/patios more than 30" off ground.