Installation Guide

3
Pre-drill oversized holes through lattice and moulding
(drill
the largest hole that screw head will allow without fi tting
though)
. Center each screw in oversized holes and do not
overtighten to allow for expansion and contraction of lattice
If the lattice bows, loosen attaching screws, make sure you
have allowed enough gap for expansion and contraction.
Place fasteners 24" apart.
DO NOT use for horizontal Installation.
Along the top, drill and fasten every 24". Drill holes
and hang through both moulding and panel.
Along the sides and bottom, drill holes and put
screws through moulding only.
Allow a 1/4" gap on all sides for expansion with cap
and divider mouldings.
Installing With Cap & Divider Mouldings:
Important Things To Remember:
1
1
•
•
•
•
•
•
2
2
3
3
4
4
Wood
Lattice
Lattice
Moulding
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
1/4" (6,35 mm)
24"