Installation Guide

6
Repeat by digging next hole and fi lling with 6" of gravel. Then insert
the next panel into the previously installed post. Place the next post
into the dug hole and slide the post onto the rails of the panel as far
as possible.
Pour concrete around that post and tamp down, leaving concrete
about 2" from ground level. Repeat until end of line.
Corner posts require some additional handling on one of the fence
panels. The rails of one panel need to be notched
1
⁄
1
⁄
1
2
⁄2⁄
" to allow the
rails to nest adequately within a corner installation.
3
3
4
4
Rail
Post
Top view of corner post
Rail
1
1
⁄
⁄
1
⁄
1
1
⁄
1
2
⁄2⁄
"
"
1
1
⁄
⁄
1
⁄
1
1
⁄
1
2
⁄2⁄
"
"
5
5
6
6
Once four or so panels are installed, check to make sure all posts
and panels are still level. If a correction needs to be made, use a
rubber mallet while the concrete is still somewhat soft.
After concrete has set, fasten the fence section to the posts
using #*8 x 1" self-tapping screws. Be careful not to over-tighten
screws because screw heads may break off or strip out.