Installation Instructions

7
Connect Rails to Brackets:
a. Press top rail cap and bracket covers onto the top rail
that was cut in step 1 onto the top of the panel. Press
down on the top rail cap to ensure that it  ts snug
onto the panel and that the top rail bracket covers are
being held in place by the line bracket (Fig. 8).
b. Using the holes in the bracket as a guide, pre-drill
two (2)
1
1
1
8
8
" holes from under the bottom of the rail
up through the top rail. Drive two (2) 1
5
5
5
8
8
" screws up
though the hole locking the bracket, panel and top rail
together, being careful not to drill though the top of
the top rail (Fig. 9).
c. Install pyramid post top onto each post (Fig. 10).
NOTE:
A rubber mallet may be needed for a proper  t.
Install The Glass Slats:
a. Snap gaskets into bottom rail slots (Fig. 11).
b. Place approxiately
1
1
1
16
16
" bead of clear weatherproof
silicone caulk (sold separately) inside each bottom
glass gasket prior to placing glass slat into place (Fig. 12).
c. Slide top gasket over the glass slat (Fig. 13.) and
place glass slat into top rail. Position glass slat to
allow them to "drop into" the bottom rail gasket.
d. Slide top rail gasket up into top rail ensuring a snug  t
(Fig. 13).
e. Repeat for all other slats.
5
6
Fig. 10
Pyramid
Top
Post
Attaching Bottom Rail Bracket Cover:
Test  t the rail panel. Once proper  t is ensured, press
bottom bracket covers onto the ends of the bottom rail
(Fig. 7) and set panel in place onto brackets previously
mounted on posts.
3
Fig. 7
Bottom Bracket Cover
Install Support Block:
Pivot support block in place under the rail (Fig. 5).
NOTE:
If using a section longer than 6', use two (2) support
blocks (included with 8' panels) and distribute evenly
across length of panel. Secure support block(s) to the
mounting surface using 1
1
1
1
2
2
" screw(s) provided and
press cover into place using plastic plug(s) (Fig. 6).
4
Fig. 5
Fig. 8
Glass
Glass
Glass
Glass
Gasket
Glass
Glass
Glass
Glass
Fig. 13
Fig. 9
Gasket
Fig. 11
Fig.6
Bottom Rail
Glass Baluster
Bottom Glass
Gasket
1
1
1
16
16
" Bead of Silicone
Fig. 12