BOM-3410XXXX Aluminum Railing Gate Kit INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: freedom.barretteoutdoorliving.
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Not pool code approved. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.
1 Determine Your Gate Opening: Fig. 1 Measure opening between posts where gate will be located. Subtract 61⁄4" from opening. This is the length you will cut your rails for gate (Fig. 1). Measure Opening (Not to Exceed 48") NOTE: Maximum width of opening between posts is 48". 2 Cut Rails To Desired Length: 3 Assemble Rails For Gate: Fig. 2 Top Rail Opening Facing Up Align bottom rail, top rail and top rail cap. Cut all to same lengths with a fine-tooth carbide blade. a.
Assemble Brackets To Uprights: Fig. 7 a. For Cambridge and Winchester styles: From bottom of upright mark at 1". This is the location of the bottom of the bottom bracket (Fig. 7). 3213⁄16" For VersaRail styles: From bottom of upright mark at 11⁄2". This is the location of the bottom of the bottom bracket (Fig. 8). 1" b. Align bottom of bracket to this line. Fig. 8 c. Pre-drill holes though upright and aluminum with ⁄8" drill bit.
6 Mount Hinges To Gate: Fig. 15 a. Center the provided Boerboel® butterfly hinges on the upright to align with the top and bottom rails of gate and mark screw holes. b. Pre-drill holes (Fig. 15). c. Screw in with two (2) screws (provided with hinge). Hinge Tension Adjustment NOTE: HINGE TENSION IS PRE-SET AT THE FACTORY AND USUALLY DOES NOT REQUIRE ADJUSTMENT. If you wish to change tension setting/gate swing speed, or completely disable the self-closing feature, please see the following: a.
7 Mounting The Cross Braces: Fig. 18 a. On one side of gate, extend the first brace across gate to the uprights, noting one side will be adjacent to hinge (Fig. 18). b. Once length is determined, mark brace in center with pencil line (Fig. 19). c. Pre-drill though the two provided brace holes with 1⁄8" drill bit. Then, secure brace together at the measured length with provided #8 x 3⁄8" blunt end screws (2) in the center of the brace (Fig. 20). Fig. 19 d. Attach brace to uprights.
Transferable Limited Lifetime Warranty What is covered: Barrette Outdoor Living warrants vinyl and aluminum products to include; vinyl and aluminum fence, vinyl and aluminum railing and plastic lattice against defects or workmanship for as long as you own your home. Barrette Outdoor Living will at its option replace the product in question with new product of the same or equivalent value at no charge.
BARRETTE OUTDOOR LIVING 7830 FREEWAY CIRCLE MIDDLEBURG HEIGHTS, OHIO 44130 TEL: (800) 336-2383 WWW.FREEDOM.BARRETTEOUTDOORLIVING.