Installation Guide

ManualsBrandsFreedom ManualsFence Gates73024668

INSTALLATION INSTRUCTIONS

Ready-to-Assemble

Vinyl Picket Gates -

Ready-to-Assemble

Vinyl Picket Gates -

Ready-to-Assemble

Without Cross Braces

FREEDOM-WEB

Read all instructions prior to installing product.

Refer to manufacturers safety instructions when operating any tools.

To register your product, please visit:

freedomproduct.com

Summary of content (5 pages)

PAGE 1
FREEDOM-WEB Ready-to-Assemble Vinyl Picket Gates Without Cross Braces INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: freedomproduct.
PAGE 2
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the gate or individual. • Not pool code approved. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.
PAGE 3
NOTE: Components shown are for visual reference only and may not depict the exact style of your product. Please see product label for correct number of pieces.
PAGE 4
1 2 Lay gate components on a smooth, flat and clean surface. Begin by arranging the rails in the correct orientations. Fig. 1 1 Pickets For Styles With Two Rails: a. Slide the pickets into the bottom rail. If pickets are numbered, follow the sequence from left to right (Fig. 1). b. Slide the top rail over the pickets (Fig. 2). For Styles With Three Rails: Bottom Rail a. Slide the pickets into the bottom rail. If pickets are numbered, follow the sequence from left to right (Fig. 1). Fig. 2 b.
PAGE 5
4 Ensure gate is square. Measure diagonally from top of left corner rail (A) to bottom of right corner rail (B) and note the length. Then, measure diagonally from top of right corner rail (C) to bottom of left corner rail (D). Note the length. Make sure both measurements are the same before installing screws into uprights (Fig. 5). Fig. 5 A D 5 Install two provided 6" screws through each upright insert and into the rail using the molded grooves on the insert as a guide (Fig. 6). C B Fig.