Installation Guide

5
4
5
6
7
Ensure gate is square. Measure diagonally from top of
left corner rail (A) to bottom of right corner rail (B) and
note the length. Then, measure diagonally from top of
right corner rail (C) to bottom of left corner rail (D). Note
the length. Make sure both measurements are the same
before installing screws into uprights (Fig. 5).
Fig. 5
A
D
C
B
Install two provided 6" screws through each upright
insert and into the rail using the molded grooves on the
insert as a guide (Fig. 6).
NOTE:
For some styles, the #2 square extender
bit may be needed to reach the insert inside
the upright.
Install upright caps onto the top of each upright with
remaining vinyl cement (Fig. 7).
Fig. 6
Fig. 7
Install Boerboel
®
hinges according to hardware
instructions.