Installation Guide

3
1
2
Mark the fence location using string and line stakes (Fig.
1).
NOTE:
Plan gate placement, opening and hardware
clearance before installing fencing.
a. Dig the  rst two post holes. Hole size should be
dug based on the following determination: Depth is
determined by your local frost line measurements
plus 6" for gravel/ ller (Fig. 2). Width is determined
by the post size.
See chart below for measurements.
Diameters based on post size:
10" for 5" x 5" post
8" for 4" x 4" post
b. Insert 6" of gravel/ ller into the bottom of both holes
and then set the  rst post into the ground and level it.
c. Add wet or dry concrete mix according to
manufacturer's instructions to the top of the  rst
post hole only and assure your post remains level
(Fig. 3).
Fig. 1
Fig. 2
5x5 Post
Example:
Frost
Line
Gravel/
Filler
6"
10"
Fig. 3
Post
Concrete
Gravel/Filler