Installation Guide

ManualsBrandsFreedom ManualsDeck Rails73032053

Assemble Your Railing Section:

a. Place top and bottom rail on a smooth,  at and

clean surface. Then, align the top and bottom

rails so that the ridges inside the rails are

oriented on the same side (Fig. 6).

NOTE:

There are two (2) ridges on both sides that

are different sizes.

b. Push all balusters through the holes in rails,

being careful to have the hole in each baluster

going in the same direction facing the side with

the two (2) small ridges (Fig. 7).

c. Make sure the balusters in the rails are about

2" above the rail and in-line with each other

(Fig. 7).

d. Snap in bumps from locking strip into holes

of the baluster for both top and bottom rails.

Make sure arrows on locking strip face rails

(Fig. 8).

e. If the rails were cut shorter in step 3, then there

will be some extra locking strip at the end of

install. Use scissors or a utility knife to trim off

the excess, while leaving approximately 2" after

the last engaged bump.

f. Pull the top and bottom rails towards ends,

guiding the rails over the locking strips until

snug.

g. Stand rail section up and fully lock balusters

into the rails. Place one foot on the top of the

bottom rail, between the second and third

baluster while at the same time placing a hand

under the bottom of the top rail between the

second and third baluster. Push with foot and

pull with hand until locking is completed. You

should hear a snap as the strip locks into the

rail. Repeat this process for the middle and the

end of the panel (Fig. 9).

NOTE:

If no snap is heard or felt, use a rubber

mallet to tap underneath of top rail to

ensure a full connection.

h. Line up hand rail pro le on top of the top rail.

Press it down onto the top rail so it  ts snug.

i. Slide bracket covers on ends of both top and

bottom rails (Fig. 10).

Fig. 7

Two Large Two Large

Ridges Side

Fig. 9

Arrows

Pointing Down

Fig. 8

Arrows

Fig. 6

Top Rail Opening Facing Up

2 Small Ridges

2 Large Ridges

Bottom Rail Opening Facing Down

2 Small Ridges

Fig. 10

Two Small

Ridges Side