BARRETTE-WEB Vinyl Post & Rail/Ranch Rail INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: barretteoutdoorliving.
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Not pool code approved. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-800-336-2383. BEFORE YOU BEGIN: TOOLS NEEDED: Check your local zoning laws.
2-Rail 3-Rail 4-Rail Crossbuck 3
1. 2. Mark the fence location using string and line stakes (Fig. 1). Fig. 1 NOTE: Plan gate placement, opening and hardware clearance before installing fencing. Post Location: Measure the width of the rails (X) plus the width of the post (Y). This is the common center-to-center measurement (unless there is a cut-down rail) for post hole location (Fig. 2). Fig. 2 Y X Post Installation: Dig the first two post holes.
4. 5. 6. For 2-Rail, 3-Rail, & 4-Rail, insert bottom rail into bottom post route hole of first post only, then do the same for the middle & top rails accordingly. If using 16' Rails, alternate rails so rail ends do not begin at the same post (Fig. 4). Fig. 4 For Crossbuck Styles, insert bottom rail into bottom post route hole, then first cross rail, followed by second cross rail, and finally the top rail accordingly (Fig. 5) Fig.
BARRETTE OUTDOOR LIVING 7830 FREEWAY CIRCLE MIDDLEBURG HEIGHTS, OHIO 44130 TEL: (800) 336-2383 WWW.BARRETTEOUTDOORLIVING.