Installation Guide

11
a. Cut out bracket template from side of post box.
Refer to angle bracket components (Fig. 1).
b. Align bottom of template with top of the base trim and
secure in place with a piece of tape.
c. Follow instructions on template for pre-drilling using a
1
⁄
1
⁄
1
8
⁄8⁄
" drill bit, then remove the template.
d. Align top and bottom bracket bases with covers
attached (Fig. 2) with the holes ensuring that they are
square. Fasten bracket bases in place using the non-
painted  at head 1
1
⁄
1
⁄
1
2
⁄2⁄
" screws provided.
a. Temporarily assemble top and bottom level angle
brackets. Mounting brackets slide into bracket base,
bracket cover is aligned, and the bracket is fastened
together using the hinge bolt provided (Fig. 3).
b. Align panel on desired angle and mark the top rails
(Fig. 4) and bottom rails (Fig. 5).
c. Repeat this on the other side of the panel. Label the
top of the rail panel to simplify installation.
2
3
Bottom Bracket
Stair Bracket Base
Bracket
Cover
Hinge Bolts
Top Bracket
Fig. 1
Fig. 2
Pre-Drill
Stair Bracket
Base
Hinge Bolt
Top Bracket
Fig. 3
Fig. 4
Fig. 5