Installation Guide

ManualsBrandsFreedom ManualsDeck Post Sleeves(Fits Common Post Measurement: 4-in x 4-in; Actual: 4.25 x 45.0 x 4.25) White Aluminum Deck Post Sleeve

a. For the bottom rail only, add

⁄

⁄4⁄

" (toward the rail end or

post (Fig. 6) to the marks made on the panel in step 3

(Fig. 5) and cut the panel at these marks.

b. For the top rail, cut the panel directly on the marks

made in Step 3 (Fig. 4).

c. Cut the top rail to the same length.

3/4"

Fig. 6

Assemble Railing Section:

a. Place top and bottom rail on a smooth,  at and clean

surface. Then, align the top and bottom rails so that

the ridges inside the rails are oriented on the same

side (Fig. 7).

NOTE:

There are two (2) ridges on both sides that are

different sizes.

b. Insert all balusters through the square holes in rails,

making sure the hole in each baluster goes in the

same direction facing the side with the two (2) small

ridges (Fig. 8).

c. Make sure the balusters in the rails are about 2"

above the rail and in-line with each other (Fig. 8).

d. Snap in bumps from locking strip into holes of the

baluster for both top and bottom rails. Make sure

arrows on locking strip face rails (Fig. 9).

e. If the rails were cut shorter in step 3, then there will

be some extra locking strip at the end of install. Use

scissors or a utility knife to trim off the excess, while

leaving approximately 2" after the last engaged bump.

f. Pull the top and bottom rails towards ends, guiding

the rails over the locking strips until snug.

Fig. 7

Top Rail Opening Facing Up

2 Small Ridges

2 Large Ridges

Bottom Rail Opening Facing Down

2 Small Ridges

Fig. 8

Two Large Two Large

Ridges Side

Two Small

Ridges Side

Arrows

Pointing Down

Fig. 9

Arrows