Installation Guide

g. Stand rail section up and fully lock balusters into the

rails. Place one foot on the top of the bottom rail,

between the second and third baluster while at the

same time placing a hand under the bottom of the top

rail between the second and third baluster. Push with

foot and pull with hand until locking is completed.

You should hear a snap as the strip locks into the rail.

Repeat this process for the middle and the end of the

panel (Fig. 10).

NOTE:

If no snap is heard or felt, use a rubber mallet to

tap underneath of top rail to ensure a full

connection

Install Support Block:

Pivot support block in place under the rail (Fig. 12).

NOTE:

Secure support block to the mounting surface using

⁄

⁄2⁄

" screw(s) provided and press cover into place

using plastic plug (Fig. 13).

a. Remove the hinge bolts from the bottom brackets.

Remove the bottom brackets from the bracket bases,

and insert the bottom brackets into each end of the

bottom rail (Fig. 14).

b. Slide the bottom bracket (and rail) into the bottom

mounting base while setting the top rail on top of the

top rail bracket.

c. Reinsert the hinge bolt through the bottom brackets

to lock assembly into place.

Fig. 11

Fig. 12

Fig. 13

Hinge Bolt

Top Bracket

Fig. 14

Locked

Fig. 10

Side Views of Rails

and Locking Stripsand Locking Strips