Installation Guide

14
8
Fig. 15
Connect Rails to Brackets:
a. Press top rail bracket end covers onto each end of
the top rail cap that was previously cut. Press down
on the top rail cap to ensure that it  ts snug onto the
panel and that the top rail end bracket covers are
being held in place by the line bracket (Fig. 15).
b. Using the holes in the bracket as a guide, pre-drill
two (2)
1
⁄
1
⁄
1
8
⁄8⁄
" holes from under the bottom of the rail
up through the top rail. Drive two (2) 1
5
⁄
5
⁄
5
8
⁄8⁄
" screws up
through the hole locking the bracket, panel and top
rail together, being careful not to drill through the top
of the top rail (Fig. 16).
c. Install pyramid post top onto each post (Fig.17).
NOTE:
A rubber mallet may be needed for a proper  t.
Fig. 16
Fig. 17
Pyramid Top
Post