Installation Guide

7
Fig. 21
End Cap
Line Cap
Corner Cap
Cover
Strip
Screw
Cover
Strip
Line Cover
Snap/slide aluminum screw cover strip (from post
kit) into place by holding cover approximately 6"
from top of post.
Hook one side of the cover and push down to snap
the other side.
Slide the cover down the post to hide the screws
(Fig. 21).
Install post cap to top of post. Use a soft rubber
mallet if necessary to obtain a  rm  t. (Fig. 21)
Each post comes with sixteen (16) screws, but not
all screws are used in each assembly. For additional
security, use remaining screws to fasten in ll boards
to posts. Screws should be distributed evenly
between top and bottom sections of the rail and
used on each end of the boards. Locate screws
midway between all three rails (halfway between
mid and top rail, halfway between mid and bottom
rail) for best results. These screws will go into the
channel aligned with screws used to lock rails into
place (Fig 20).
Assemble post base trim over plate. Take one side
of trim ring and push plastic plugs through hole
underneath. Take second half of the trim ring and
push together (Fig. 22). Slide over plate for a  nished
look.
Fig. 22
Fig. 20
Distribute screws
evenly (minimum 1
per center)
15
16
17