Installation Guide

Lay gate upright on a smooth, at and clean surface.

Slide upright inserts inside ends of gate uprights (Fig. 1).

Apply vinyl cement to all inside surfaces of the rst

upright where the rails will be inserted (Fig. 2).

Insert both rails into one upright assembly (Fig. 3).

a. Place the U-channels on the end boards, then slide

boards into rails, locking them together (Fig. 4).

b. Apply vinyl cement to all inside surfaces of the

second upright where rails will be inserted.

c. Attach the remaining upright assembly to the rails

making sure boards t snug.

Gate Upright

Upright Insert

Fig. 1

Vinyl Cement

Upright

Assembly

Fig. 2

Upright

Assembly

Rails

Fig. 3

Fig. 4

U-Channel

Boards

U-Channel

Measure diagonally from top of left corner rail (A) to

bottom of right corner rail (B) and note the length. Then,

measure diagonally from top of right corner rail (C) to

bottom of left corner rail (D). Note the length. Make

sure both measurements are the same before installing

screws into uprights (Fig. 5).

Fig. 5