Manualshelf

Installation Guide

ManualsBrandsFreedom ManualsBuilding SuppliesEmblem 6-ft H x 7-ft W Sand Vinyl Flat-Top Fence Panel
12
Transition Panel Kit
READ INSTRUCTIONS PRIOR TO INSTALLATION
INSTALLATION INSTRUCTIONS
Posts
Post Hole Digger/Shovel
Concrete
Coarse Gravel/Filler (6" per hole)
Jig saw
Tape Measure
Pencil
TOOLS/MATERIALS NEEDED:
WARNING:
• Improper installation of this product can result in personal injury. Always
wear safety goggles when cutting, drilling and assembling the product.
• Incorrect installation may cause harm to the product or individual.
• Check local building codes to determine pool-safe fencing options.
NOTICE:
• DO NOT attempt to assemble the kit if parts are missing or damaged.
• DO NOT return the product to the store. For assistance or replacement parts
call: 1-800-336-2383.
Panel Kit Components:
QTY. Description
2
Rails
14 or
15
Boards
(depending on kit ordered)
2
U-Channels
Panel With
Decorative Rails
Panel With
Standard Rails
Rails
Boards
U-channels
1. Before beginning, the top post route on the taller (6') side will need to be opened a small amount to accept the angled rail. Follow the guide based on
panel ordered. Measure from the top of the route to the designated measurement and mark with a pencil (Fig. 1). Using a jig saw, cut away the excess
material.
NOTE:
Bottom of the top
route is the only
portion that should
be cut away. The top
of the route should
remain as-is.
3"
5"
5"
5"
3"
Standard
Rail Routes
Decorative
Rail Routes
Fig. 1a Fig. 1b
Measure and cut to 5-13/16"
Measure and cut to 7-5/16"
Decorative Rail Measurements
Decorative Rail Measurements
NOTE:
This is a decorative rail and is recommended to cut the steps at
the designated measurements.
Standard Rail Measurements
Standard Rail Measurements
2. Follow level panel instructions for fence location,
post location and post installation.
3. Insert bottom rail into bottom post route holes.
4. Lay out and number all in ll boards from left to
right with board #1 being the longest (Fig. 2).
Attach U-channels to outer boards.
Fig. 2
Board #1
5. Starting with board #1 (longest board), install in ll boards from left to right in numerical order.
NOTE:
Transitioning from 6'-5' will use 15 boards;
Transitioning from 6'-4' will use 14 boards
6. Insert top rail into the left side of the post route then guide over top of boards.
7. Insert the completed fence panel into the route hole of the second fence post. Plumb and level the posts and add
concrete according to manufacturer’s instructions (Fig. 3).
Fig. 3
BARRETTE OUTDOOR LIVING
7830 FREEWAY CIRCLE
MIDDLEBURG HEIGHTS, OHIO 44130
TEL: (
800) 336-2383
• WWW.FREEDOMPRODUCT.COM
To obtain and review a copy of the warranty please go to: Freedomproduct.com/warranty.
You can also contact 1.888.418.4400 or write to Freedom Outdoor Living,
7830 Freeway Circle, Middleburg Heights, Ohio 44130 to obtain a copy of the warranty.
To register your product, please visit:
FreedomProduct.com
FREEDOM-WEB

Summary of content (2 pages)