Installation Guide

Fig. 6

Ensure gate is square. Measure diagonally from top of

left corner rail (A) to bottom of right corner rail (B) and

note the length. Then, measure diagonally from top of

right corner rail (C) to bottom of left corner rail (D). Note

the length. Make sure both measurements are the same

before installing screws into uprights (Fig. 6).

Install two 6" screws (provided) through each upright

insert and into the rail using the molded grooves on the

insert as a guide (Fig. 7).

Install upright caps onto the top of each upright with

remaining vinyl cement (Fig. 8).

Fig. 7

Fig. 8

Fig. 9

Screws

Upright

Attaching Boerboel

Hinge To The Upright:

a. Attaching the hinges to the inside of the gate

will allow the gate to open inward. When attaching

them to the outside, the gate will swing outward.

b. Mark and pre-drill

⁄

⁄32⁄

" pilot holes on top and

bottom upright. Secure using six 1

⁄

⁄2⁄

" screws (provided

with the hinge) to front and side of the upright (Fig. 9).

Repeat for the bottom hinge.

Fig. 10

Hold the gate level to the post, pre-drill holes with

⁄

⁄32⁄

bit and secure with six 1

⁄

⁄2⁄

" screws to the post (Fig. 10).

Repeat for the bottom hinge.

NOTE:

Use 2" blocks to align the gate with the fence and help

hold the gate steady (Fig. 11).

2" Blocks2" Blocks

Gate

Fig. 11