Assembly Instruction

BLF1102014 Lever Table Lamp
BLF1102014
Lever
Table
Lamp
Assembly Instructions
Please read all instructions before commencing
installation even if you feel you are quite familiar
with this type of product.
Assembly instructions:
1. Follow these instructions closely as deviation
may void your warranty and present a
possible safety risk.
2
Remove the table lamp from the packaging
2
.
Remove
the
table
lamp
from
the
packaging
and dispose of packaging materials
thoughtfully.
3. Before you begin to use this table lamp check
all parts have been supplied.
4. It is recommended that any assembly is
performed on a soft surface to avoid any
damage.
5
Ensure the power is switched off at the wall
5
.
Ensure
the
power
is
switched
off
at
the
wall
socket and DO NOT connect at this stage.
6. Fit the shade to the lamp holder by removing
the ring ‘A’, fitting the shade ‘B’ over the
threaded section of the lamp holder ‘C’ and
replacing the ring ‘A’.
7. Screw the pole ‘E’ onto the fitting ‘D’ making
sure that the thumb screw ‘F’ is loose so that
the
p
ole ‘E’ can turn freel
y
. Do not hold F and
py
H when screw the pole “E” onto the fitting “D”.
8. Tighten thumbscrew ‘F’ at a point where the
clamping bracket is halfway between the top
and the bottom of the tube ‘E’.
9. Screw the pole ‘I’ to pole ‘E’ making sure that
the guide ‘G’ is fitted over pole ‘E’.
10.Screw the base ‘J’ to the bottom of pole ‘I’.
11.Draw the cable down throu
g
h the small tube
g
and secure the cord anchorage screw ‘K’
adjusting the angle of the lever pole so that it
is at approximately 15 degrees from
horizontal.
12.After initial assembly adjust the angle of the
lever pole by releasing the thumb screw ‘F’
and sliding the adjustment assembly up and
down.
WARNING:
• This table lamp must be connected to a 240V 50Hz
power source.
13.Screw the E27 25W CFL max (not included)
into the lamp holder ensuring that it is
secured firmly. Do not over tighten.
14.Plug the cord into the selected wall socket,
turn the wall socket on and switch the table
lamp ON using the switch located on the
cord.
• Ensure that the switch is in the off position and the plug
is removed from the wall socket when changing light
globes.
• Light globes are extremely hot when in use. Always
remove globes only when they have cooled to room
temperature.
• This table lamp is not intended for use by children or
infirm persons without supervision.
Y hild h ld b i d t th
SPECIFICATIONS:
Fitting: Metal table lamp with metal
shade head.
Globe: 240V E27 max 25W CFL
Construction: Class II
•
Y
oung c
hild
ren s
h
ou
ld
b
e superv
i
se
d
t
o ensure
th
ey
DO NOT play with this table lamp.
• This table lamp is not designed for outdoor use.
• Ensure that the globe is at least 30cm from the
nearest object at all times.