freeView Power 80 Remote Power Control P/N: KPM-008M User's Manual

28
RPM: Select the unit in the stack on which to take action.
Outlet: Select the outlet in the unit on which to take action.
Outlet Action: Set whether the outlet should be turned on or off.
Date: The date to activate the event. Can be set to a single date in “yyyy/mm/dd” format or
occur on a daily or weekly basis.
Time: The time in “hh:mm” format to activate the event.
4.2.13 Save/Restore Settings
The Save/Restore Settings page (Figure 32) allows you to back up the system settings to a your
local hard drive, restore system settings from a back up file, or reset the device to factory
defaults.
Figure 32 – Save/Restore Settings Page
Save current configuration: Click the “Save” button to save a config.bin file to your local hard
drive as a back up of the current system configuration. This file can also be uploaded to other
freeView Power 80 units to copy the settings to the other unit.
Restore previous configuration: Click “Browse…” and select the config.bin system
configuration backup file that was previously saved to your hard drive. Then click the “Restore”
button to upload the configuration file.
Reset to factory default: Resets all settings back to the factory defaults.
4.2.14 Event Log
The Event Log page (Figure 33) displays the events that have occurred on the unit.