freeView Power 80 Remote Power Control P/N: KPM-008M User's Manual
32
4.4.1 Logging In
To manage the freeView Power 80 using a touch tone telephone, the unit must be connected to
a live telephone line.
Dial the phone number of the freeView Power 80.
After three rings, the unit will answer with two short beeps.
Enter your dial-in password followed by the “#” key. (The default password is 123456789)
If the password is correct, you will hear two short beeps. If the password is incorrect, you will
hear one long beep.
Once logged in, you can issue instructions to the unit. If you are inactive for 180 seconds, the
unit will automatically log you out.
4.4.2 Managing Power Ports
Each outlet can be turned on, turned off, and reset using special number combinations
representing different instructions. The instructions are either 4 or 8 numbers, and follow the
pattern described below.
Instruction format: AABC# or AABCDDDD#
AA – The unique ID of the unit between 00 and 16. Single digit IDs must be entered as two
digits (e.g. enter “05” instead of “5”). If there is no daisy chain present, any number is accepted.
B – The power outlet number on the unit (1 through 8). Pressing 9 affects all of the outlets.
C – The action to perform. Available actions are: 0 to turn an outlet off, 1 to turn an outlet on,
and 2 to reset an outlet.
DDDD – The delay in minutes before performing the action (this is optional). The longest delay
is 9999 minutes, or 166.65 hours.
After entering the command, press the “#” key to perform the action. You can press “*” to cancel
the instruction at any time.
Examples:
• 0150# will turn off Outlet 5 on Unit 1
• 1271# will turn on Outlet 7 on Unit 12
• 0022# will reset Outlet 2 on Unit 0
• 03400060# will turn off Outlet 4 on Unit 3 in 60 minutes
• 06210720# will turn on Outlet 2 on Unit 6 in 720 minutes (12 hours)
• 14122880# will reset Outlet 1 on Unit 14 in 2880 minutes (48 hours, or 2 days)
• 0290# will turn off all of the Outlets on Unit 2.
• 0491# will turn on all of the Outlets on Unit 4.
• 1192# will reset all of the Outlets on Unit 11 after 8 seconds.
Enter “000#” to disconnect from the freeView Power 80.