User Manual

38| AIRCRAFT FLIGHT MANUAL
RADIO CHANNEL MAPPING
ALTA 6 can be used with a variety of radio controllers. Different radio controllers
can map functions to different channels, so properly mapping controller channels
to ALTA 6 functions is an important step before flying. Radio channel mapping is
performed using the ALTA App.
This section describes the steps required to complete radio channel mapping.
If you are uncertain about your radio channel mapping, obtain assistance from an
experienced pilot or from Freefly Customer Support.
CONFIGURATION JUMPER
A small jumper is used to prevent motor operation while configuring radio channel
mapping parameters. With the jumper in place, the motors may operate, but radio
channel mapping is prevented. With the jumper removed, radio channel mapping
may take place, but motor operation is prevented.
To remove or replace the Configuration Jumper:
1. Locate the closeout panel between booms 5 & 6 where the jumper is installed
2. Remove the closeout panel using a 1.5mm hex driver