User's Manual

General Operation
Using Your Headset for the First
Time
Step One: Attach Adapter
Fit adapter to the accessory interface of the
portable radio (see your portable radio’s user
manual if you need assistance locating the ac-
cessory interface). If your adapter has a mount-
ing clip on top, this will fit into a corresponding
notch on top of your portable radio. If your
adapter does not have a mounting clip, use the
set screw (see diagram) to secure it to your radio.
When properly attached, the spring-loaded pins
should align with the contacts on the accessory
interface of your portable radio and adapter
should fit securely.
Step Two: Turn On Adapter
Turn on your portable radio and set toggle
switch to “On” position. (see diagram) Note that
this will automatically silence the speaker on
your portable radio and route all communica-
tions to the headset.
Step Three: Exit Sleep Mode
Your headset will be in Sleep Mode when you
take it out of the box for the first time. To awak-
en your headset from Sleep Mode, depress the
PTT button once, or unplug it from the charger.
Once you have awakened your headset from
Sleep Mode, it automatically enters Seek Mode
(see definition above).
Step Four: Pair Headset to Adapter
When you take your headset out of the box for
the first time, you will need to pair it with an
adapter manually. To initiate manual pairing,
hold the headset close to the adapter and
simultaneously depress the Volume Up and Vol-
ume Down buttons on the headset for 10 seconds.
When you have successfully paired your headset
to the adapter, the adapter LED will turn solid
green and then begin flashing green, indicating
a link has been established.