MODEL: PFR2190NG SETTING THE AIR PRESSURE DEPTH ADJUSTMENT NATL-DRY-FIRING MECHANISM P10 MAINTENANCE P10 RECOMMENDED HOOKUP P11 TROUBLESHOOTING P12 WEARABLE PANTS P12 WARRANTIES P13 WARNING: The wakings and precautions discussed In this manual cannot cover all possible conditions and institution that may occur. Plazas be aware of the potential hazards, and take all necessary precautions to avoid risk of Injuries.
MODEL: PFR2190NG Free Man @Do not use on a ladder or unstable ‘supports. Stable footing on a dolls surface enables better control of the tool In unexpected situations. ®Make sirs the hiss Is fees of obstructions or snags. Entangled or snarled hoses can cause loss of balance or fooling and may become damaged, resulting in possible injury. ® Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables W cancer and birth defects or other reproductive harm.
MODEL: PFR2190NG Such precautionary measures reduce the risk of injury to persons. LOADING TOOL ® Do not load the tail with fasteners when any one of the operating controls s ‘activated. @ Over pace a hand or any part of body In Ta stoner discharge area of tool. @ Over point the tool at anyone. @Do not pull the trigger or depress the workplace contact as accidental actuation may occur, possibly Free Man FEATURES SPECIFICATIONS AR CONSUMPTION: 12.
MODEL: PFR2190NQ MODEL: PFR2190NG Free Man A WARNING: Allures to do so could result In serous personal Binary. A\ WARNING: Nev or load fasteners with the workplace contact or trigger activated. Doing so «could result In serious personal Injury. Unfading Is the reverse of loading, except always disconnect the tool from the alr source before unloading. A warning: Always unload all fasteners before removing the tool from service. A WARNING: Always disconnect the alr source before unfading.
MODEL: PFR2190NG Mainframe care should be taken because a nails will be driver when the work contact element is pressed against any surface. Since the tool can he actuated without removing the finger from the trigger, this Is mode, A WARNING: During normal use the tool will ecol Immediately after driving a fastener. This Is a normal function of the tool. Do not attempt to prevent the recoil by holding the tool against the work.
Free Man MODEL: PFR2190NG TROUBLESHOOTING A warning: Stop using tool immediately if any of the following problems occur. Serious personal Injury could result. Any repairs or replacements must be dons by a qualified service person or an authorized service counter. O-rings in trigger valve housing are | Replace o-tings on trigger valve. damaged. Air leaking at the rigger Heck operation of Work Contact valve area. Element (WC. Alr leaking batsmen 1. Looss screws In housing. 1.Tighten screws.
