Instructions / Assembly

1. Remove existing fitting from tool.
2. Place belt hook at desired angle.
3. If the nailer is designed for use with a
3/4” fitting, screw the 1/4” fitting into
the included brass bushing.
4. Screw the fitting/bushing into the nailer
and tighten to ensu and tighten to ensure a leak-free seal.
1. Remove existing fitting from tool.
2. Place belt hook at desired angle.
3. Screw the new fitting and belt hook
(already assembled) into the nailer and
tighten to ensure a leak-free seal.
1. Remove existing fitting from tool.
2. Place belt hook at desired angle.
3. Insert fitting into belt hook, then screw
the fitting into the nailer. Tighten to ensure
a leak-free seal.
4. Optional: Add rubber washers (not
included) for a tighter fit. included) for a tighter fit.
BELT HOOK INSTALLATION