Owner's Manual

ASSEMBLY

ssembly requires two persons.

et the treadmill in a cleared area and remove all packing materials.

o not

dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal

condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off

the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver . For help

identifying the assembly hardware, see the drawings below.

The number in parentheses below each drawing

is the key number of the part, from the PART LIST on pages 26 and 27. The number following the parentheses is

the quantity needed for assembly.

Note: Some small parts may have been preassembled. If a part is not in

the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do not use

power tools for assembly.

Star Washer

(90)–10

Upright Bolt (72)–4

3/4” Screw (4)–4

Handrail Bolt (64)–6

1. Make sure that the power cord is unplugged.

With the help of a second person, raise the front

of the treadmill and insert the crossbar on the

Base (83) into the cutout in the cardboard stand

as shown. Make sure that the treadmill is se

curely held on the cardboard stand by a sec-

ond person.

WARNING: Serious injury may

occur if the treadmill moves forward or back-

ward and falls off the cardboard stand. A sec-

ond person must hold the treadmill during as-

sembly to prevent the treadmill from moving,

tipping, or falling.

Cardboard

Stand