Owner's Manual

ADDITIONAL ADJUSTMENTS

Handle End Adjustment

ools required: 1/8" hex key, cable cutters, torque

wrench, utility knife

Note: Make this adjustment only if the pulley in the

weight carriage has been fully adjusted to the bottom

of the slot in the bracket and the cable requires more

tension.

Note: This adjustment is only for increasing the cable

tension, because it requires shortening the cable. Only

one end of the cable should be shortened.

1. Create slack in the cable by removing the weight

pin and pulling either handle out six to eight

inches.

Insert the weight pin into the third weight plate and

the tube on the bottom of the weight carriage.

2. Push the black rubber cable stop off the aluminum

cable lock and slide the cable stop upward a few

inches.

3. Loosen the four set screws in the cable lock and

pull the cable free.

4. Cut off one inch of the cable end using cable cut-

ters. Note: Using any other tool may flatten or

disrupt the end strands so that it may be diffi-

ult to reinsert the cable into the hole of the

cable lock.

5. Cut off one inch of the black cable sheath from the

end of the cable.

6. Reinsert the cable and the sheath into the cable

lock so that all of the bare cable is in the hole.

7. Retighten the four set screws into the threaded

holes. Tighten the set screws equally until they

contact the cable. Then, tighten each screw alter-

nately 1/4 turn, until all are set to 85 inch/pounds

(9.6 Newton-meters).

8. Slide the rubber cable stop over the cable lock,

remove the weight pin, and lower the handle.

9. Check for proper tension on the cable as

described in CABLE ADJUSTMENT, on page 8.

Cable Stop

Cable

Cable Lock

Set Screws