Owner's Manual

10
10. Attach the Left Front Upright (90) to the left
Support (6) with two M10 x 77mm Bolts (85), two
M10 W
ashers (65), and two M10 Nylon Locknuts
(64).
Do not tighten the Locknuts yet.
Repeat this step with the Right Front Upright
(not shown).
11. Orient a Slanted Guide Bumper (88) as shown.
Attach the Bumper and a Guide Rod (8) to the left
Side Base (3) with an M10 x 80mm Bolt (84), two
M10 Washers (65), a 7mm Spacer (47), a 12mm
Spacer (80), and an M10 Nylon Locknut (64). Do
not tighten the Locknut yet. Make sure the
12mm Spacer is on the Floor Plate (23) side of
the Guide Bumper.
Attach the other Slanted Guide Bumper (88)
and Guide Rod (8) to the right Side Base (not
shown) in the same manner.
10
11
6
64
65
65
85
90
64
8
88
Low
Side
High
Side
47
80
65
65
3
84
23
64