Owner's Manual

14
23. Orient the Locking Bar (35) as shown.
Slide the W
eight Bar (32) through the left Glider
(15), the Locking Bar (35), and the right Glider.
Engage the hooks on the Locking Bar (35) onto
the hook knobs on the Front Uprights (4, 90).
26.
Wrap the Butterfly Cable (61) over a “V”-pulley
(51).
Attach the “V”-pulley and a Large Cable
Trap (52) to the Center Upright (5) with an M10 x
58mm Bolt (81) and an M10 Nylon Locknut (64).
Make sure the Cable T
rap is oriented to hold
the Cable in the groove of the “V”-pulley
.
24. Press a 48mm Adapter Bushing (34) into a
Barbell Adapter (33).
Attach the Barbell Adapter (33) to the Weight Bar
(32) with an M10 Large Washer (66) and an M10
x 30mm Button Bolt (79).
Repeat this step on the other side of the
Weight Bar (32).
Tighten two M8 x 25mm Screws (77) into the
Gliders (15).
Tighten the M10 Nylon Locknuts (64) used in
steps 2–20.
25. Locate the Butterfly Cable (61). Attach the
Cable to the Right Fly Arm (12) with an M8 x
60mm Shoulder Bolt (71) and an M8 Nylon
Locknut (86). Make sure the flat edge of the
eyelet on the Cable is against the Fly Arm.
23
32
15
90
Hook
Knob
15
4
35
24
25
26
32
15
77
33
34
66
79
71
86
Flat
Edge
12
61
61
81
52
51
64
5
Cable Assembly