Owner's Manual

17
35. Route the Long Cable (63) over a 90mm Pulley
(50) and down through the Rear Top Frame (10).
Attach the Pulley inside the
Top Frame with an
M10 x 77mm Bolt (85), two M10 Washers (65),
two 17mm Spacers (49), and an M10 Nylon
Locknut (64).
37. Wrap the Long Cable (63) over a 90mm Pulley
(50). Attach the Pulley and a Cable Trap (16) to
the second set of holes from the bottom of the
Large Double “U”-bracket (43) with an M10 x
50mm Bolt (82) and an M10 Nylon Locknut (64).
Make sure the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
39. Wrap the Long Cable (63) over a 90mm Pulley
(50).
Attach the Pulley to the Small Double “U”-
bracket (44) with an M10 x 45mm Bolt (73) and
an M10 Nylon Locknut (64).
38. Wrap the Long Cable (63) under a 90mm Pulley
(50).
Attach a 3mm Spacer (48) and the Pulley to
the Center Base (2) with the M10 x 73mm Bolt
(74) used in step 36 and an M10 Nylon Locknut
(64).
36. Wrap the Long Cable (63) under a 90mm Pulley
(50). Attach the Pulley to the Center Base (2) with
an M10 x 73mm Bolt (74).
Do not thread a lock-
nut onto the Bolt yet.
35
36
37
38
39
49
50
49
85
74
63
50
2
65
65
64
63
10
63
50
50
48
64
2
74
44
50
63
73
64
62
16
64
82
43