Owner's Manual

20
48. Press two 40mm x 50mm Inner Caps (115) into
the Backrest Frame (99).
Attach the Backrest Bracket (100) to the Backrest
Frame (99) with two M10 x 75mm Bolts (125) and
two M10 Nylon Locknuts (64).
50.
Press a 50mm Round Inner Cap (1
19), a 50mm
Round Slotted Cap (87), and a 48mm Round
Inner Cap (31) into the Leg Lever (96).
Orient a Leg Lever Plate (98) as shown.
Attach
the Plate to the Leg Lever (96) with two M10 x
71mm Carriage Bolts (124), two M10 Washers
(65), and two M10 Nylon Locknuts (64).
Attach the other Leg Lever Plate (98) to the
Leg Lever (96) in the same manner. Make sure
the Plate is oriented as shown.
49. Pull out the Bench Knob (118) that is toward the
Bench Stabilizer (95). Insert the Backrest Bracket
(100) into the Bench Frame (94) as shown.
Engage the Knob into a hole in the Backrest
Bracket.
Pull out the other Bench Knob (118) and insert the
Seat Bracket (120) into the indicated slot in the
Bench Frame (94). Engage the Knob into the
highest hole in the Seat Bracket.
Lightly grease an M10 x 130mm Bolt (128). Attach
the Seat Frame (97) and the Backrest Frame (99)
to the Bench Frame (94) with the Bolt, two 3mm
Spacers (48), and an M10 Nylon Locknut (64). Do
not overtighten the Locknut; the Seat and
Backrest Frames must be able to pivot easily.
See the inset drawing. Attach an M10 x 20mm
Bolt (127) and an M10 Nylon Locknut (64) to the
round hole on the Seat Bracket (120).
48
99
115
115
100
125
64
49
50
97
120
94
65
98
98
96
65
64
118
87
1
19
31
124
118
95
120
127
64
64
48
99
128
Grease
100
Slot