Owner's Manual

TIGHTENING THE CABLES

oven cable, the type of cable used on the weight

bench, can stretch slightly when it is first used. If

there is slack in the cables before resistance is felt,

the cables should be tightened. Make sure that the

cables are not too tight, or the weight carriage will be

lifted.

See drawing A. Slack can be removed from the

cables by moving the 90mm Pulley (50) to a higher

set of holes in the Large Double “U”-bracket (43).

Remove the M10 Nylon Locknut (64) and the M10 x

50mm Bolt (82) from the “U”-bracket. Reattach the

Pulley and the Cable Trap (16) with the Bolt and

Locknut. Make sure that the Cable Trap is posi-

tioned to hold the cable in place and that the

cable and Pulley move smoothly.

See drawing B. Additional slack can be removed

from the cables by tightening the Long Cable (63) into

the M8 Nylon Locknut (86) inside a Clip (54). To do

this, pull the Clip Cover (53) back and use a pair of

pliers to tighten the Locknut. Replace the Cover.

Note: If a cable tends to slip off the pulleys often,

the cable may have become twisted. Remove the

cable and re-install it.

If the cables need to be replaced, see ORDERING

REPLACEMENT PARTS on the back cover of this

manual.