Owner's Manual

7
4. Attach the Foot Plate (19) to the Center Base (2)
with two M10 x 80mm Bolts (84) and two M10
Nylon Locknuts (64).
Do not tighten the
Locknuts yet.
5. Align the holes in the Center Base (2) with the
holes in the Rear Base (1). Insert two Tall Guide
Bumpers (89) and two Carriage Guides (7) into
the holes.
Note: The indicated holes in the Tall
Guide Bumpers are closer to the edge than in
the Short Guide Bumpers (not shown).
Attach the Carriage Guides (7) and the Center
Base (2) to the Rear Base (1) with two M10 x
80mm Bolts (84), two 12mm Spacers (80), two
7mm Spacers (47), four M10 Washers (65), and
two M10 Nylon Locknuts (64).
Do not tighten the
Locknuts yet.
4
5
19
84
2
7
7
64
64
65
89
Hole
89
1
2
84
84
47
80
65
65