Owner's Manual

12
11. Attach the Weight Carriage Frame (18) to the
W
eight Carriage Guides (21) with two M8 x 40mm
Bolts (52) and two M8 Nylon Locknuts (8). Do
n
ot tighten the Nylon Locknuts yet.
11
12. Locate the indicated holes inside the Center
Upright (13). Insert an M10 x 25mm Screw (1
18)
into the lower hole, and tighten the Screw into
the Weight Carriage Frame (18). Next, tighten an
M10 x 25mm Screw into the upper hole.
Press a 75mm Square Inner Cap (95) into the
Top Frame (17).
See step 9. Tighten the M10 Nylon Locknut
(37). See step 11. Tighten the M8 Nylon
Locknuts (8).
12
18
18
13
95
118
17
52
8
2
1
13. Grease the top of the Right Adjustment Bracket
(24), and insert it into the Top Frame (17). See
the inset drawing. Orient two Bracket Retainers
(73) so that the teeth bend
upward. Using the
included retainer tool, tap the Bracket Retainers
onto the
Right
Adjustment Bracket.
Attach the Right Adjustment Bracket (24) to the
T
op Frame (17) with an M10 x 30mm Screw (54),
an M10 Lock W
asher (86), an M10 Large W
asher
(7), and a Bushing Cap (88).
Do not overtighten
the Screw; the Right Adjustment Bracket must
pivot easily.
Attach the Left Adjustment Bracket (25) in the
same way.
13
54
7
86
24
25
Grease
17
24
88
73
Retainer
T
ool
Holes