Owner's Manual

17
25. Wrap the Arm Cable (43) over a “V”-pulley (75).
Attach the “V”-pulley, a Large Cable Trap (77),
a
nd two Full Pulley Guards (76) to the other side
of the bracket on the Center Upright (13) with an
M
10 x 60mm Bolt (55) and an M10 Nylon Locknut
(37). Make sure that the Large Cable Trap is
oriented to hold the Arm Cable in the groove
of the “V”-pulley.
25
26. Grease an M8 x 22mm Shoulder Bolt (45). Attach
the Arm Cable (43) to the Right Adjustment
Bracket (24) with the Shoulder Bolt and an M8
Nylon Locknut (8). See the inset drawing. Make
sure that the flat edge of the cable is against
the Right Adjustment Bracket. Do not over-
tighten the Shoulder Bolt; the Arm Cable must
pivot easily.
26
27. Identify the High Cable (81). Feed the High
Cable under the indicated rod into the right Swivel
Bracket (31). Continue feeding the High Cable
into the Top Frame (17), and then pull the end of
the High Cable out of the indicated slot in the To p
Frame.
Wrap the High Cable (81) over a Large Pulley (4).
Attach the Large Pulley inside the Swivel Bracket
(31) with an M10 x 55mm Bolt (119), two M10
Washers (41), two M10 x 6.5mm Spacers (38),
and an M10 Nylon Locknut (37).
27
119
41
4
38
37
31
81
17
55
43
37
76
13
7
7
7
5
76
45
Grease
38
41
24
8
45
43
43
8
24
Rod
Ball
Slot