Owner's Manual

21
36. Identify the Rear Cable (94). Press the Weight
Carriage Block (100) into the Weight Carriage
(19). Insert one end of the Rear Cable into the
the center of the Weight Carriage Block. Attach
the Rear Cable and the Weight Carriage Block to
the Weight Carriage with an M10 x 65mm Bolt
(51), two M10 Washers (41), two M10 x 20mm
Spacers (39), and an M10 Nylon Locknut (37).
37. Route the Rear Cable (94) through the Weight
Carriage Frame (18) as shown. Insert a Small
Pulley (74) into the slot in the Weight Carriage
Frame.
Then, insert another Small Pulley (74).
Attach each Small Pulley with an M10 x 55mm
Bolt (119), two M10 Washers (41), two M10 x
6.5mm Spacers (38), and an M10 Nylon Locknut
(37).
36
37
38
38
Slot
1
19
38
41
41
37
74
94
18
19
94
51
39
39
37
41
41
100
35. Wrap the High Cable (81) over a Large Pulley (4).
Attach the Large Pulley inside the Swivel Bracket
(
31) with an M10 x 55mm Bolt (119), two M10
Washers (41), two M10 x 6.5mm Spacers (38),
a
nd an M10 Nylon Locknut (37).
Remove the M8 Jamnut (2) from the High Cable
(81), and slide the Cable Stop (6) onto the Cable.
Next, tighten the Jamnut onto the Cable as far as
possible, tighten the Cable Eyelet (5) onto the
Cable as far as possible, and then tighten the
Jamnut against the Cable Eyelet. Then, slide the
Cable Stop down onto the Cable Eyelet.
3
5
37
2
5
119
38
41
41
31
4
81